Published Papers
     Search Papers (Springer,
   After 2008)
     Search Papers (Dbpia,
   Until 2007)
     Search Papers (JMST
   own data base)
       - Classification By Year   
       - Classification By Topic
     Special Issues
   
           
   
 
 
Subject Keyword Abstract Author
 
 
Analysis of plastic penetration in process of groove ball-section ring rolling

L. Hua
The Journal of Mechanical Science and Technology, vol. 22, no. 7, pp.1374-1382, 2008

Abstract : Plastic penetration is a necessary condition of ring rolling forming. In this paper, based on the principle of groove ball-section ring rolling and characteristics of plastic penetration, a three dimensional (3D) finite element (FE) analysis model for the plastic penetration of ball groove-section ring is established under the ABAQUS software environment. A decisive factor for plastic penetration behavior, namely the penetration speed of plastic zone£¬has firstly been ascertained. The distribution pattern of the plastic zone in the process of plastic penetration is revealed by 3D simulation. By researching the diffusion rules of the plastic zone under the conditions of different ring radial thickness and feed speed, the influences of ring radial thickness and feed speed on plastic penetration are obtained. Lastly, the necessary condition for the plastic penetration of groove ball-section ring rolling is summarized, and is validated by experiment and simulation. The achievements of this study expressly reveal the plastic penetration rules of groove ball-section ring rolling, and it¡¯s useful for technology design and production.

Keyword : Ring rolling; Groove ball-section; Plastic penetration; FE; Simulation

 
 
 
 
 
JMST Editorial Office: #702 KSTC New Bldg, 22 7-gil, Teheran-ro, Gangnam-gu, Seoul 06130, Korea
TEL: +82-2-501-3605, E-mail: editorial@j-mst.org
JMST Production Office: #702 KSTC New Bldg, 22 7-gil, Teheran-ro, Gangnam-gu, Seoul 06130, Korea
TEL: +82-2-501-6056, FAX: +82-2-501-3649, E-mail: editorial@j-mst.org